樂清市谷本電氣有限公司

概述  Outline

本智能型一體化變電站是華電電氣公司推出的國產化美式箱變。該產品作為電纜化配電網中重要的供電單元，集高壓控制、保護、變電、以及配 電設備于一體的成套預裝產品，廣泛應用于城鄉配電網之中。該產品將高壓負荷開關、高壓熔斷器置于變壓器油中，具有與變壓器身共箱或分箱兩種 結構形式。油箱采用全密封結構，配有油溫表、油位表、壓力表、壓力釋放閥、放油閥等元件監測變壓器運行狀況。該產品分為環網型、終端型及電 源型供電方式。為了使此種產品更適合于我國電網的實際要求，華電公司又推出了插拔型干式熔斷器，熔絲的熔斷不影響變壓器油的性能。根據低壓 饋出要求的復雜程度，此產品分為標準型、加強型和綜合型三種外殼形式，使用戶和設計單位在選型時，做到更靈活、更經濟。

This intelligent integrated transformer substation is a nationalized type American box substation developed by HUADIAN ELECTRIC Company. As an important power supply unit in the cable distribution network, it is an in tegrated prefabricated product of high voltage control, protection, power transformation and power distribution, whichis widely used in the urban and rural distribution network.The high voltage load switch and high voltage fuse are put into the transformer oil, so this product has two structure forms of one box and divided box with the transformer body. The oil box is of full-sealed structure with oil temperature indicator, oil level gauge, pressure gauge, pressure relief valve and oil drain valve to monitor the operation condition of the transformer. This kind of products has three types of power supply modes ring network type, terminal type and power type. In order to make the product meet the actual demands of the power grid in China better, HUADIAN Company promotes plug-pull dry type fuse and the fusing of the fuse wire has no effect to the performance of transformer oil. According to the complicated degree of low voltage outgoing demands, this product has three types of enclosure - standard type, reinforced type and integrated type, as a result, the clients and design agents have more choices.

型號及含義  Model and meaning

使用環境條件   Use environmental conditions

1. 環境溫度：高溫 +40℃，低溫 -30℃ 

2. 海拔：≤ 1000m; 3. 風速：相當 34m/s( 不大于 700Pa) 

4. 濕度：日相對濕度平均值不大于 95%, 月相對濕度平均值不大于 90%； 

5. 防震：水平加速不大于 0.4m/s2; 垂直加速不大于 0.15m/s2; 

6. 安裝地點傾斜度：不大于 3° ; 

7. 安裝環境：周圍空氣不受腐蝕性，可燃性氣體等明顯污染，安裝地點無劇烈震動； 

8. 訂購本產品超出上述條件的規定時，可與本公司協商。

1.Ambient temperature: maximum +40℃ , minimum-30℃ ;

2. Altitude: ≤ 1000m；

3. Wind speed: About34m/s ( ≤ 700Pa);

4. Humidity: Average daily relative humidity ≤ 95% Average monthly relative humidity ≤ 90%

5. Shake-roof: Level acceleration ≤ 0.4m/s2;vertical acceleration ≤ 0.15m/s2;

6. Gradient of installation position: ≤ 3° 

7. Installing environment: ambient air has not been obviously polluted by corrosive or flammable gas, andthere is no strong feeling of shock.

8. Please negotiate with the company when the purchased product is beyond above stipulated conditions.

產品額定參數 Product rated parameters

絕緣水平   Insulation level

結構特點 Structural features

箱殼骨架結構采用槽鋼及角鋼制造，有較高的機械強度，外殼采用鋁合金板等材料制造，表面光滑平整，產品美觀大方，且具有較好的防腐性能。 箱體的基座高出地基 300~600mm. 柜殼的門均向外開，開啟角度大于 90°，且設定位裝置。并裝有把手。暗門和能防雨、防堵、防銹的暗鎖。箱體均為全密封防盜結構；為保證 在一般周圍空氣溫度下運行時，電器設備的溫度不超過其較大允許溫度，箱體設有足夠的自然通風口和隔熱措施。預裝式變電站的箱體設有專 用接地導體，該接地導體上設有與接地網相連的固定連接端子，其數量為兩個以上，有明顯的接地標志。接地端子直徑不小于 12mm 有銅質螺栓。接 地導體采用銅帶，其電流密度不大于 200A/mm2 截面不小于 30mm2，并保證流過較大短路電流時不發生過熱和影響周圍物體的安全。專用接地導體 所承受的動、熱穩定電流應與高壓配電裝置的接地方式相配合。

The framework structure of the box enclosure is made of channel steel and angle steel with higher mechanical strength. the enclosure is made of aluminum alloy plate with smooth surface, beautiful outline and better anticorrosion performance. the base of the box body is 300~600mm higher than the ground.All the doors of the box enclosure are open to outside, and the opening angle is larger than 90° and is set with location device, handles, secret door, as well as built-in locks which have the functions of rain protection, anti-blockage and rust protection. the box bodies are of the full-sealed theft-proof structure. to assure the operation under the normal ambient air temperature, the temperature of all the electrical equipment can't exceed the maximum allowable temperature, and the box body has enough natural ventilation openings and heat insulation measures. the box body of the prefabricated substation is designed with special grounding conductor, on which there are more than 2 fixed connecting terminals connected to the grounding network and on which there are obvious grounding marks. the grounding terminal is the copper bolt, the diameter of which is not less than 12mm. the grounding conductor is made from copper strip, the current density of which is not higher than 200A/mm2 and the cross section of which is not less than 30mm2 . and it is guaranteed that there is no overheat and there is no bad effect to the safety of the surrounding objects when the maximum short circuit current passes. the dynamic and thermal stability current that the special grounding conductor endures must be combined with the grounding mode of high voltage power distribution device.

變壓器性能參數 Transformer performance parameters 

10kV 預裝式變壓站用 S9、S10、S11 系列油浸式變壓器性能水平

For 10kV prefabricated substation performance level of S9, S10, S11 series oil-immersed transformer

注：a. 根據顧客要求變壓器的高壓分接范圍可設計為 ±2×2.5％。

       b. 根據顧客要求變壓器的低壓可設計為 0.69kV。 

       a. The high-voltage tapping range can be designed to ±2×2.5% according to customer's requirement. 

       b. The low voltage of transformer can be designed to 0.69kV according to customer's requirement.

變壓器性能參數 Transformer performance parameters 

負荷開關性能參數 Performance parameter of load switch

主回路方案圖 Schematic diagram of main circuit 

注：a. 插入式熔斷器與后備限流熔斷器的額定值由制造廠家按變壓器容量確定。

       b. 進線可加裝高壓帶電指示器或故障指示器。 

       c. 根據需要可加裝高壓計量裝置。

       a. The rated values of plug-in type fuse and backup current limiting fuse are subject to transformer's capacity by manufacturer. 

       b. High-voltage charged indicator or fault indicator can be extra installed for incoming line. 

       c. High-voltage metering device can be extra installed according to requirement.