浙江佳怡電氣有限公司

產品簡介 Product introduction

XL-21 低壓動力柜適用于發電廠及工礦企業中，在交流電壓 500 伏及以下的三相四線或三相五線系統作動力配電之用。XL-21 低壓動力柜系戶內裝置靠墻安裝，屏前檢修。

XL-21 low-voltage power cabinet is suitable for power distribution in power plants and industrial and mining enterprises, in three-phase four-wire or tn-s system with AC voltage of 500 volts or less. XL-21 low-voltage power cabinet is an indoor device installed against the wall and overhauled before the screen.

型號說明 Model description

結構特點 Design feature

XL-21 低壓動力柜系封閉式，柜體由冷扎鋼板或不銹鋼彎制焊接而成 , 刀開關操作手柄裝于柜前右柱上部，可以作為切換電源之用。動力柜前面裝有一只電壓表，指示母線的電壓。動力柜前面有門，門打開后，動力柜內全部設備敞露、便于檢修維護。具有結構緊湊，檢修方便，線路方案可以靈活組合等特點。動力柜除裝有空氣斷路器和熔斷器作為短路保護外，還裝有接觸器和熱繼電器，柜前門可裝操作按鈕和指示燈。

XL-21 low-voltage power cabinet is closed, the cabinet body is made of cold-rolled steel plate or stainless steel bent and welded, and the knife switch operating handle is installed at the upper part of the right column in front of the cabinet, which can be used for switching power supply. A voltmeter is installed in front of the power cabinet to indicate the voltage of the bus. There is a door in front of the power cabinet. After the door is opened, all the equipment in the power cabinet is exposed, which is convenient for maintenance. It has the characteristics of compact structure, convenient maintenance and flexible combination of line schemes. Besides air switch and fuse as short-circuit protection, the power cabinet is also equipped with contactors and thermal relays, and the front door of the cabinet can be equipped with operation buttons and indicator lights.

正常使用條件 Normal use conditions

◆環境溫度：-50℃ ~+40℃，且 24h 內的平均溫度不超過 +36℃；

◆海拔高度：不超過 2000m；

◆相對濕度：在周圍空氣濕度為 +40℃時不超過 50%；在較低濕度下可以有較高的相對濕度 ( 如：+20℃時為 90%)，考慮到溫度的變化允許產生適度的凝霜；

◆設備安裝時與垂直面的傾斜度應不超過 5°，設備應安裝在無劇烈震動、無沖擊及無腐蝕的場所。

◆ Ambient temperature: -50℃ ~+40℃ , and the average temperature within 24h does not exceed+36℃ ; 

◆ Altitude: no more than 2000m；; 

◆ Relative humidity: no more than 50% when the ambient air humidity is +40 ℃ ; At low humidity, there can be high relative humidity (for example, 90% at +20 ℃ ). Considering the change of temperature, it is allowed to produce moderate frost. 

◆ When the equipment is installed, the inclination with the vertical plane should not exceed 5, and the equipment should

使用、維護和檢修 Use, maintenance and repair

低壓動力柜在安裝或檢修后，在投入運行前須進行下列各項檢查與試驗 ( 檢修后的檢查與試驗，視其檢修質性而定 )。

◆檢查動力柜內部裝設電器設備和二次接線是否符合圖紙要求。

◆檢查用于操作的刀開關、空氣開關是否靈活，應無卡軋型象。

◆檢查所裝設的電器設備的接觸是否良好，是否符合該電器設備的本身使用要求。

◆檢查動力柜內部有無其他異物及各部分堅固螺釘是否有松動現象。

After installation or maintenance, the low-voltage power cabinet must be inspected and tested in the following items before it is put into operation (the 

inspection and test after maintenance depends on its maintenance quality). 

◆ Check whether the electrical equipment and secondary wiring installed inside the power cabinet meet the drawing requirements. 

◆ Check whether the knife switch and air switch used for operation are flexible and there should be no jamming image. 

◆ Check whether the contact of the installed electrical equipment is in good condition and whether it meets the use requirements of the electrical equipment itself. 

◆ Check whether there are other foreign bodies inside the power cabinet and whether the solid screws of each part are loose.

外型及安裝尺寸 Outline and installation dimensions

注：1、以上尺寸可以任意組合 ; 2、柜體尺寸可根據客戶圖紙要求尺寸定制 ;

Note: 1. The above dimensions can be arbitrarily combined; 2. The dimensions of cabinet can be customized according to the requirements of customer drawings;

技術參數 Technical parameter

額定電壓：400V

額定絕緣電壓：690V

額定電流：630、400~10A

額定短時耐受電流：10kA

防護等級：IP30、IP44、IP54

Rated voltage: 400V 

Isolation voltage rating: 690V 

Rated current: 630,400 ~ 10A 

Rated short-term withstand current: 10kA 

Protection level: IP30, IP44, IP54

熔斷器 Fuse protector

交流接觸器 Ac contactor

訂貨須知 Ordering instructions

訂貨時客戶應提供下列資料：

◆一次線路方案及單線系統圖；

◆二次線路展開系統圖；

◆每箱內所裝各種電器設備詳細規格及數據；

◆在訂購 B 型結構時須提供動力柜的排列圖和平面布置圖。

The customer shall provide the following information when ordering: 

◆ Primary line scheme and single line system diagram; 

◆ System diagram of secondary line deployment;

◆ Detailed specifications and data of various electrical equipment in each box; 

◆ When ordering B-type structure, the arrangement diagram and floor plan of power cabinet shall be provided.